+86 21 59830621
                      sales@hbtetech.com
                      English

                      Different Types of RF Attenuator

                      Ⅰ. Why do you need an RF attenuator?


                      In RF circuits, a higher signal level is usually better. Because improving the signal level can improve the signal-to-noise ratio (SNR) and reduce problems caused by the noise of internal circuit components and noise of the external signal. As a result, higher signal levels often simplify many of the challenges of RF circuit design.


                      However, in many systems, RF signals inevitably have a wide dynamic range spanning 30, 40, or more dB; some designs must handle signals with a range exceeding 100 dB. One or two link nodes are moving, including radar or long-range radio, or even short-range LAN, and there are obstacles and interference.


                      Suppose the system is designed to work generally with lower-level signals. In that case, there may not be a margin for higher-power signals (RF, power, and signal level are usually closely related). The result is overload, saturation, and even damage to sensitive analogue components, such as front-end amplifiers. Even if there is no permanent damage, as long as the signal chain components are "maximized", the system will not work properly. In these cases, it may take a relatively long time for the component to get out of the saturation chain and become feasible again. In other cases, the attenuator matches the maximum value of the signal at one point with the maximum value of the larger limit at another range in the chain.


                      It is often necessary to manage and attenuate signal levels for these reasons. With known or controllable quantities, this is where the programmable RF attenuator comes into play.


                      Ⅱ. Different types of RF attenuator


                      A fixed RF attenuator is usually made of carbon resistors with a specific value based on the amount of attenuation required. If high-precision attenuation is required, precision resistors and calibration attenuators are required, which will increase the cost of a fixed RF attenuator. The fixed optical attenuator is a simple device, but a high-quality and high-precision attenuator can be very expensive.


                      The switch attenuator consists of a fixed resistor and a radio frequency switch. These devices allow different levels of attenuation by switching different resistors. The type of radiofrequency switch can also vary according to the required accuracy and frequency. The most basic type is a simple mechanical switch. But there are also other switching methods, including radiofrequency relays, digital switches, and others.


                      The variable RF attenuator allows for adjustable attenuation levels. Depending on the signal strength, this may be a variable resistor. The variable attenuator can be analogue or digital; in other methods, the variable programmable digital attenuator is used with integrated components to achieve variable adjustments based on power and frequency. IC (Integrated Circuit) attenuator is in chip form and is usually used on circuit boards. The test equipment may include a certain form of IC attenuator, so no external attenuator is required. The attenuation methods used in IC may vary but usually allow analogue or digital control.


                      A programmable RF attenuator can be a simple device, such as a resistor connected to two coaxial connectors for use in series. RF attenuator can also be more complex, involving switching digital circuits or more. As the frequency of the attenuator rises, its cost also rises. Likewise, as the required accuracy of the attenuation level increases, the cost is usually higher. Regardless of design and accuracy, many equipment, test equipment, and networks use RF attenuators to keep our information flowing.

                      Related News

                      Products

                      Hangzhou Yongxie Technology Co., Ltd.
                      HBTE develops, produces and markets a wide range of RF capital devices for industry, infrastructure operators, education and research institutions customers.
                      国产亚洲视频在线观看网址,精品?久久?国语,亚洲成在人线AV无码,丰满的少妇被猛烈进入白浆视频